Hello, so I stumbled across one thread at Reddit saying one of the AOC monitor is known to have problem with this, I had a strange feeling about my monitor since I had, but I never tried this test, so I decided to do so.
Result:
https://i.imgur.com/0PASLVI.jpg
I set camera on 1/5.
I already have this monitor over a year, but I never think about that, and if it is a failure, can i get a replacement?
Thanks
XL2411Z Frame Skipping?
- lexlazootin
- Posts: 1251
- Joined: 16 Dec 2014, 02:57
Re: XL2411Z Frame Skipping?
Yea, that's pretty bust and defective.
AOC really like to cut corners with their monitors.
AOC really like to cut corners with their monitors.
Last edited by lexlazootin on 18 Mar 2016, 08:20, edited 3 times in total.
-
- Posts: 5
- Joined: 17 Mar 2016, 15:18
Re: XL2411Z Frame Skipping?
Ouh Are you 100% sure of that? should i send it back?
-
- Posts: 2795
- Joined: 26 Mar 2014, 07:23
Re: XL2411Z Frame Skipping?
Are you using a VT Tweak?
- lexlazootin
- Posts: 1251
- Joined: 16 Dec 2014, 02:57
Re: XL2411Z Frame Skipping?
If your monitor says it's 144hz then it should be displaying 144 frame a second.makitofikito wrote:Ouh Are you 100% sure of that? should i send it back?
Skipping frames is pretty bad thing, i think you might be able too make it not frame skip by creating a custom resolution in your GPU control panel at 1080p 144hz but with reduced blanking.
i'm not 100% sure this will help but it's worth a shot.
-
- Posts: 5
- Joined: 17 Mar 2016, 15:18
Re: XL2411Z Frame Skipping?
Falkentyne wrote:I don't know, i was tinkering with it while ago while i was trying to use blur reduction, but in the end i didn't like it so i switched, could that be the cause?
-
- Posts: 5
- Joined: 17 Mar 2016, 15:18
Re: XL2411Z Frame Skipping?
i restarted cru settings and its the same i think..i can see that empty gap even without picture
-
- Posts: 2795
- Joined: 26 Mar 2014, 07:23
Re: XL2411Z Frame Skipping?
Run reset-all.exe from CRU, restart the driver (restart64.exe) or computer, then try again. This will remove all custom resolutions.
And is instant mode enabled or disabled in the OSD?
And is instant mode enabled or disabled in the OSD?