Hello,
I've got a GTX 780 and connected to that an Acer XB270HU via DP and an Acer XB270H via DVI. Both running at 144 Hz without any problems. The second DVI Port on the GTX 780 is connected to a Pioneer receiver, which is connected to a Sony VPL-HW40ES. I'm using Windows 8.1.
Now my problem is, every time i turn on the Pioneer receiver, Windows detects a new monitor, both Acer monitors go black for a few seconds and all refresh rates are set to 60 Hz. After that i can set them back to 144 Hz and leave the Beamer on 60 Hz, again without any issues.
Anyone got an idea how to prevent this annoying behavior?
How to prevent refresh rate auto switching?
Everything about displays and monitors. 120Hz, 144Hz, 240Hz, 4K, 1440p, input lag, display shopping, monitor purchase decisions, compare, versus, debate, and more. Questions? Just ask!
Return to “General — Displays, Graphics & More”
Jump to
- The Main Lobby
- ↳ General — Displays, Graphics & More
- ↳ News / Rumors / Conventions
- ↳ Input Lag / Display Lag / Network Lag
- ↳ Display Comfort — Eyestrain / Headaches / Motionsick
- Everything Better Than 60Hz™
- ↳ Eliminating Motion Blur — LightBoost / ULMB / ELMB / DyAc
- ↳ OLED Displays
- ↳ G-SYNC
- ↳ FreeSync
- ↳ Game Consoles — XBOX and PlayStation — ONE / Series S / Series X / PS5
- ↳ BENQ Zowie Tweaking — Strobe Utility / Blur Reduction / DyAc
- ↳ Display Overclocking
- The Laboratory
- ↳ Test UFO Motion Tests
- ↳ Area 51: Display Science, Research & Engineering
- ↳ Software Developers / Low-Lag Code / Game Programming
- ↳ Pursuit Camera Testing of Display Motion Blur
- ↳ High Frame Rate Video (HFR, UltraHFR, 120fps, 240fps, 1000fps)
- The Cafeteria
- ↳ Offtopic Lounge
- ↳ Niche Issues Affecting Latency — Electrical, Interference, EMI, Unexpected Causes, etc.
- ↳ Forum System / Registration / Suggestions