Falkentyne wrote:Hi, please use the service menu if you can't use the strobe utility.
Entry Codes are in the sticky on general section.
The strobe utility is a front end for the service menu, which has more adjustments (including ability to set strobe phase up to 100 when NOT using Vertical Total tweaks).
I tried for over an hour to enter service menu. I have 2720Z, probably with updated firmware, so when i press buttons 3+4 (counting from bottom) + power on, nothing happens. When i press power on just to turn it on for a second, then off immediately after, then on again with 3+4 pressed, nothing happens again. I can keep doing it for another hour, but i'm afraid my wife will think i gone crazy
Of course with new windows 10, strobe is not recognizing my monitor (suggestion - rewrite strobe tool to properly recognize new monitor types? but this should go to strobe author of course)
So unable to enter service menu, unable to run strobe. what else i can do?