Blur Busters Forums

What is the bandwidth cap for DisplayPort 1.4a with DSC? Can it still handle 1440p 480Hz?

Even if HDMI 2.1 is included, would that require compression as well? 1440p 480Hz requires more than 48Gbps bandwidth, no?

I'm assuming the LG model or one of the other brands will be G-Sync Compatible. With OLED monitors are there any benefits to having the G-Sync hardware vs being G-Sync Compatible? Does G-Sync perform any better, improve latency, any other performance benefits? I know with LCDs you'll get variable ov...

From my understanding (forgive me, forget where I heard or read this) Pulsar requires a new module unfortunately. :| No firmware updates for existing models for ULMB2/Pulsar, more potential ewaste.. which is unfortunate. Unfortunate. When it requires a new module is this hardware in addition to the...

Chief is ASUS giving any information right now if the PG27AQN will get an update in the future? Excited to try this in the future. Hoping I can give it a shot on the PG27AQN. I usually hold on to my monitors for quite some time but the 480Hz OLED from LG will cause me to make the jump quicker than n...

Hoping this will make its way to the PG27AQN. You would think with ULMB2 support another update could enable it. The funny wording of ASUS PG27 series is a bit worrying but also makes me wonder if the AQN is included in that lol. Was BFI mentioned anywhere? I see backlight strobing in the article bu...

Been going back and forth lately between G-Sync and ULMB 2 trying to decide what I like more, the extra clarity during motion or the consistent smoothness with G-Sync. I get around 200-220fps a lot in Apex when not capped at 300fps in 1440p. Have you decided? And how would you compare both in APEX ...

Been going back and forth lately between G-Sync and ULMB 2 trying to decide what I like more, the extra clarity during motion or the consistent smoothness with G-Sync. I get around 200-220fps a lot in Apex when not capped at 300fps in 1440p.

Is there any information right now on the ULMB 2 Pulse Width adjustment settings? The PG27AQN is defaulting to 100 with more brightness and you can adjust it by increments of 10 down to a value of 10 with the least amount of brightness. Does the motion clarity change much?

Don't forget ABL behavior. CRTs have under 200 nits too when displaying a white screen. Few white pixels = the pixels are brighter than the world's brightest BenQ Many white pixels = the pixels fall to 200 nits Reviewers will need to benchmark ABL behaviours (1%, 10%, 25%, 50%, 100% white window si...

For latency, it's unknown but historically at same Hz, OLED has more lag, and the higher Hz reduces lag even further, so the jury is still out, at least until OLED lag is optimized long-term. I would not be surprised if the 360Hz LCD is lower by a low single-digit milliseconds difference versus the...