Blur Busters Forums

Falkentyne i have problem and i hope that you can help me.. i reset monitor to factory settings and set VT trick.. i used CRU utility and NVIDIA patcher and than my screen starts shaking :O I used CRU utility and set 1500VT but if i opened nvidia control panel there was every value set to 1500VT ...

i found out that its happens only in not native resolutions...

to Falkentyne

Hi,

i set VT 1500 and strobe 0/6 on 120hz but if i start CSGO i get notice that wrong cable, that i have to use dual link.. but i have dual link... where is problem? the windows doesnt want to disappear :/

Can I ask you to write guide for me step by step how to basically everything set (strobe, VT trick, blur reduction) to XL2430T? Because I went under instructions as there are (strobe on, VT 1350, and blur on) and brightness at 39 I havent very dark picture and everyone has 100 brightness..

When enabling blur reduction the screen goes black and I can see a kind-of silhouette of the windows that are open. The 50hz setting didn't save with CRU so I just added the 1080p50 preset; didn't notice this in CCC before.

Is this what you expected?

Oh, no,
Set area/strobe phase to 0 (zero ...

Falkentyne wrote:hmm wait....what refresh rate?

120hz

i did single strob on, VT 1350 trick and turn motion blur on and my screen is only little darker then without blur.. i have brightness set to 39 :/

Intensity is (I think) persistence (clarity; lower persistence=darker screen=clearer motion because the strobe refreshes are faster).
Same thing as "strobe duty" on the Z monitors, but this was only adjustable through the service menu (or the windows utility) on the Z monitors.

Area is the same ...

Just turned on VT1350 on my 2430T. I didn't know it would make it brighter as well. At Intensity 20 and Area 0, it looks almost as good as the PG278Q on the Alien Invasion test, and the usual frame rate test looks better as well (for being brighter, I suppose).

Note: if Area is greater than ...

how can i turn strobe on?

Turn SINGLE STROBE to [ON] from the service menu.

To access the service menu, turn the monitor off, hold down the menu key (second one from the bottom) and press the power button. When the monitor powers up, press the menu key and you should be presented with a blue ...