Blur Busters Forums

Try 100Hz, before rebooting. See what happens?

Another last resort try: Try a different Custom Resolution. Try installing ToastyX Custom Resolution Utility (different utility) and installing a different calculation for one of the two modes (the non-LightBoost mode). Your monitor might begin to ...

Chief Blur Buster wrote: Try 100Hz, before rebooting. See what happens?

Thanks again for replying.

I've set it to 100Hz with lightboost enabled.

The problem is intermittent so I will monitor (excuse the pun) it for the next few days and see if it reoccurs!

Thanks for getting back so quick.

I've turned Lightboost off as you suggested but it flickered again at the login page though less pronounced this time. Rather than the entire page being an entire grey liney mess, I could largely see the image with some liney flickering distortions in sections of ...

Hi all,

I've noticed since reinstalling Lightboost for my 980 ti with benq xl2411t that on cold booting the computer, the entire windows login page picture is obscured by phasing grey lines. These take a good 10 seconds for the picture to gradually clear and I am able to see the login page picture ...

Welcome to the wonderful world of motion blur eliminating strobe backlights. :D


Hi! Thanks for your fantastically quick and complete response to my questions!

I bet you've already experienced turning ON/OFF LightBoost during http://www.testufo.com/photo and seen the remarkable ability of an ...

Bugger!

Massively gutted I didn't hear about Lightboost until after this competition was completed.. I am practically drooling at the prospect of G-sync!

Ah well, congratulations to everyone, I hope you guys have fun playing with those kits!

Hi guys,

I've only recently discovered the joys of Lightboost! However, I'm having two issues when using Lightboost with my Benq XL2411T at 120Hz (with AMD 7870 XT).

Firstly, I seem to be getting backlight bleed. I've borrowed a picture from overclockers.co.uk to show you what it looks like;
http ...