Blur Busters Forums

From what I can tell it definitely fixed the no signal detected issue that I was having when turning off the monitor and turning it back on using DP.

thank you! this got me updating to v4!
I always had an issue with v2 and DP on an ATI GPU. When I turned the monitor on and bootet my PC the ...

This is normal if no VT1350 tweak is done.
The brightness becomes brighter if you do the Vertical Total 1350 tweak.
Did you give that a try?
1350 trick with ToastyX done

Yes I did. However now I'm not sure if the settings applied correctly.
http://i.imgur.com/6FlTFLs.png

First when I made ...

Hi,
this evening I managed to upgrade my monitor with the "linux method". However I think the monitor is way too dark when I have Blur Reduction turned on. In the BlurBusters Utility I set Persistence to 2ms and Crosstalk 0. Now i don't know if this is completely normal? I dont think there is any ...

i found 3 and the one that is named in the guide was amongst them so I went on with the command list.. I personally would not change this as you may try to flash a chip, that is not to be flashed. but as you have the 2420 it might have another name, that's correct. and you only found 1?
yes, I ...

ok thank you for your help. i am a few steps further now...


it@it:~/flashrom$ sudo modprobe i2c-dev
it@it:~/flashrom$ sudo i2cdetect -l
i2c-0 i2c Radeon i2c bit bus 0x90 I2C adapter
i2c-1 i2c Radeon i2c bit bus 0x91 I2C adapter
i2c-2 i2c Radeon i2c bit bus 0x92 I2C adapter
i2c-3 i2c Radeon i2c ...

Good news, everyone!

I just managed to flash the V2 firmware on my XL2411Z, using only a VGA cable and some code I wrote.

It only requires a PC or laptop running GNU/Linux, and a video chip that exposes its I2C bus (the Intel graphic chip icluded in most laptops and recent CPUs does).

It's all ...