Blur Busters Forums

i ve done the 1350 trick now. i realised i had to turn the fader to the left again, as it's said in the tutorial, to have the clearest part of the image in the middle.. is the vt1500 trick recommended over the 1350 trick if i dont use under 120hz?

2 questions: 1.: I read it uses EDID do you have to enable the usage of EDID in the CC? there is a checkbox for that.. but it was not checked by default it seems. 2.: Change Vertical Total to “1350″ If using NVIDIA Control Panel, edit “Vertical Total” If using ToastyX CRU instead, select “Vertical” ...

you can always try to adjust the colors to a good setting! i found that in most profiles (where it is possible) i had to lower the (G)reen value more than the others to get a balanced picture. you can also try to load .icm profiles for the monitor. MBR does reduce the color intensity and the brightn...

for the 2411Z this is not very clear in all the postings I read about it so far, so I'm gonna try to explain it with the respective number of the buttons 1. Monitor has to be off for at least 5 seconds 2. hold the 2nd button from the left 3. briefly press the ON/OFF button 4.wait at least until the ...

@thread starter: in your first post you describe sth that could be a cross strobe effect not purely ghosting, try to go a bit to the right with the bottom slider in the blurbusters utility, with it set to the far left the bottom part of your screen, where perhaps your guns in tf2 are shown ;) will b...

I did the update. but I cannot access service menu. I hold the second (from the left) button and briefly press the on button (2411z): then the screen starts without ben-q eycare logo. but there is a) no menu and b) the only reaction i get from the buttons then is either nothing or the input selectio...

I have to go back to work now ;) but one question, the power button now was orange instead of green is that normal Make sure you exit the burn-in mode. Bring up the menu (one of the buttons brings up the "burn in" menu) and then change burn in from "On" to "Off" i'm at work now, will be gone home s...

hey guys, I'm happy it worked using my old laptop from 2002. good thing I hadn't recycled that old piece yet :D no errors at all and what I noticed the reading process was more than twice as fast.. ! so if you got a really slow reading (like 30min+) in the initial dumping process I personally would ...

ok i try to read the content of the flash (didnt it to it at the end after the writing error? i think so.. there was no error, only with the writing) -> the veryfying. sudo ./flashrom -p mstarddc_spi:dev=/dev/i2c-1:49 -c "MX25L1605A/MX25L1606E" -r backup2.bin that's what you meant (i just changed th...

md5sum is correct. history does not show results only commands I see. so shall i try it again with that file? shall i search for another vga cable or change anything from the last time? and why did it take so long what could that be, maybe a hint to the problem?