Did I use VT Tweak correctly? [Benq xl2430t]

Adjusting BENQ Blur Reduction and DyAc (Dynamic Acceleration) including Blur Busters Strobe Utility. Supports most BenQ/Zowie Z-Series monitors (XL2411, XL2420, XL2720, XL2735, XL2540, XL2546)
Post Reply
DrakeAndJosh5
Posts: 1
Joined: 28 May 2024, 10:41

Did I use VT Tweak correctly? [Benq xl2430t]

Post by DrakeAndJosh5 » 28 May 2024, 11:02

I use Blur Reduction + VT 1500 at 120hz [DisplayPort] (img below)

How do I verify if the VT tweak is working? I read that the monitor OSD would report the current resolution @60hz, but mine shows 120hz (indicating that it's not working properly?)

Is there a step that I'm missing? Settings are:
Blur Reduction: On
Intensity: 22
Area: 46
BenQ XL2430T
Attachments
img.png
img.png (2.26 MiB) Viewed 495 times
res.png
res.png (26.92 KiB) Viewed 495 times

User avatar
Chief Blur Buster
Site Admin
Posts: 11726
Joined: 05 Dec 2013, 15:44
Location: Toronto / Hamilton, Ontario, Canada
Contact:

Re: Did I use VT Tweak correctly? [Benq xl2430t]

Post by Chief Blur Buster » 28 May 2024, 14:53

1. Viewing the same mode in both ToastyX CRU and NVIDIA CRU is a good way to confirm. Sometimes one utility adds a mode that doesn't properly save (and not visible in both utilities). So view via at least two Custom Resolution Utilities.

2. Your crosstalk at www.testufo.com/crosstalk should go down dramatically, with much less top/bottom crosstalk, once you've used Blur Busters Strobe Utility to center the clearest crosstalk-free zone. You can try faster motion speeds (e.g. 1440 or 1920 pixels/sec) to amplify the visibility of strobe crosstalk.

Image
Head of Blur Busters - BlurBusters.com | TestUFO.com | Follow @BlurBusters on Twitter

Image
Forum Rules wrote:  1. Rule #1: Be Nice. This is published forum rule #1. Even To Newbies & People You Disagree With!
  2. Please report rule violations If you see a post that violates forum rules, then report the post.
  3. ALWAYS respect indie testers here. See how indies are bootstrapping Blur Busters research!

Post Reply