Zowie XL2540 Blur Reduction Intensity/Area settings

Adjusting BENQ Blur Reduction and DyAc (Dynamic Acceleration) including Blur Busters Strobe Utility. Supports most BenQ/Zowie Z-Series monitors (XL2411, XL2420, XL2720, XL2735, XL2540, XL2546)
Post Reply
Posts: 1
Joined: 08 Dec 2018, 06:37

Zowie XL2540 Blur Reduction Intensity/Area settings

Post by dabum155 » 08 Dec 2018, 06:39

Hello guys,

does it matter on which values these two settings are? Does it have a negative input if i activate Blur Reduction? What would be the best settings for FPS games and low input lag?

Best Regards

User avatar
Chief Blur Buster
Site Admin
Posts: 7475
Joined: 05 Dec 2013, 15:44
Location: Toronto, Ontario, Canada

Re: Zowie XL2540 Blur Reduction Intensity/Area settings

Post by Chief Blur Buster » 11 Dec 2018, 23:09

It's geometry based -- one location of screen will always have the worst lag and a different location on screen will always have the lowest lag. Lag shifts when the crosstalk zone shifts. The lowest lag is always the area right above the crosstalk zone and the highest lag is always the area right below the crosstalk zone. It's in the FAQ near the bottom of the Blur Busters Strobe Utility page.

These images are for 120Hz, your will be 240Hz so halve all the numbers shown (4ms instead of 8ms)

Images of http://www.testufo.com/crosstalk while calibrating strobe adjustments:



The input lag is a timing interaction between sequential top-to-bottom LCD scanout versus the all-at-once global backlight flash.

With Blur Busters Strobe Utility, you can move the crosstalk zone up/down while simultaneously watching a TestUFO test pattern, without needing to go into the Factory menu.



More animations: in this thread.
Head of Blur Busters - BlurBusters.com | TestUFO.com | Follow @BlurBusters on Twitter

       To support Blur Busters:
       • Official List of Best Gaming Monitors
       • List of G-SYNC Monitors
       • List of FreeSync Monitors
       • List of Ultrawide Monitors

Post Reply