PG279Q ULMB One Ghost Image
Posted: 17 May 2018, 20:23
I'm using a PG279Q and I haven't found a way to capture and image but it's easy to explain: I'm seeing a single a single ghost a little bit behind on the UFO test. The main UFO is very clear and looks as good as my old LightBoost monitor but that single ghost is quite distracting and visible in gaming and other applications.
I've enabled ULMB at 85, 100, and 120 and it all does the same thing. I'm not sure if this is normal for this monitor.
I upgraded from a VG248QE where I used ToastyX's stobe tool to use LightBoost and I had 0 ghosts.
I really hope I'm just overlooking something but I can't seem to figure this one out. G-Sync disabled, no overdrive (although when ULMB is enabled that feature is disabled in the menu so I'm assuming it doesn't matter) everything settings-wise looks ok.
Thanks for any help or anyone else that has this monitor.
I've enabled ULMB at 85, 100, and 120 and it all does the same thing. I'm not sure if this is normal for this monitor.
I upgraded from a VG248QE where I used ToastyX's stobe tool to use LightBoost and I had 0 ghosts.
I really hope I'm just overlooking something but I can't seem to figure this one out. G-Sync disabled, no overdrive (although when ULMB is enabled that feature is disabled in the menu so I'm assuming it doesn't matter) everything settings-wise looks ok.
Thanks for any help or anyone else that has this monitor.