I do not really know why but after some adjusting and trials to optimize the settings via the BenQ Service Page all over sudden it works !Chief Blur Buster wrote:Can you quickly double check if "DDC/CI" is turned on via your monitor?Rennkuckuck wrote:I use NVidias latest official driver 335.23 and use the DVI cable that came with the monitor. Also tried another DVI Dual Link cable - with the same result. I do not have a DP cable and my notebook does only have VGA and HDMI output.
Also, Strobe Utility may also work over VGA (which has a DDC line), however it will likely only work at lower refresh rates.
Failing this, continue using the Service Menu settings while viewing moving photos at http://www.testufo.com/photo in Height-> Full Screen. This will help you calibrate via the Service Menu. Strobe Duty will affect brightness, and Strobe Phase will adjust the vertical positioning of the ghosting zone, while doing the VT1350 trick will allow you to hide most of the ghosting zone in the blanking interval between refreshes.
I did the 1350 line adjustment again, and saved some settings via the BenQ Save settings - i.e. Gamer 1 function? Is there a relation in this? Or was it just coincidence that it works now?