Optimal FPS cap with frame generation?
Posted: 22 Nov 2026, 02:24
For normal non-framegen, there is a formula to which you need to cap your FPS for optimal latency with VRR, like:
Refresh - (Refresh × Refresh / 3600)
This results in the following FPS caps for a given refresh rate:
120Hz = 116 FPS
240Hz = 224 FPS
360Hz = 324 FPS
540Hz = 459 FPS
As you can see from this, the higher the Hz, the more safety margin you seemingly need. Only 4Hz @ 120Hz margin compared to 81Hz @ 540Hz.
My question now is: Wouldn’t frame gen allow to use more of the display Hz range?
Say I’m using 6x frame gen, with 540Hz, you only need 90 FPS. Lets assume that base FPS = Hz when using frame gen, that would result in the following fps caps:
Multiplier: 540/X = FPS cap * X = VRR Hz
6x: 90 FPS/Hz = 88 FPS * 6 = 528 Hz
5x: 108 FPS/Hz = 105 FPS * 5 = 525 Hz
4x: 135 FPS/Hz = 130 FPS * 4 = 520 Hz
3x: 180 FPS/Hz = 171 FPS * 3 = 513 Hz
2x: 270 FPS/Hz = 250 FPS * 2 = 500 Hz
Given that the safety margin gets larger to account for the not perfectly precise frametime limiting, am I right to assume that you should be able to limit your FPS as shown above?
If yes, then you could get around 69 Hz more motion clarity compared to non-framegen, with the trade-off of more latency of course. But given that modern titles are nowhere near 1% low 459 FPS even with the fastest PC you can buy, frame gen sounds like a very good option, especially considering you need good 1% lows to reduce VRR flicker.
Thanks!
Refresh - (Refresh × Refresh / 3600)
This results in the following FPS caps for a given refresh rate:
120Hz = 116 FPS
240Hz = 224 FPS
360Hz = 324 FPS
540Hz = 459 FPS
As you can see from this, the higher the Hz, the more safety margin you seemingly need. Only 4Hz @ 120Hz margin compared to 81Hz @ 540Hz.
My question now is: Wouldn’t frame gen allow to use more of the display Hz range?
Say I’m using 6x frame gen, with 540Hz, you only need 90 FPS. Lets assume that base FPS = Hz when using frame gen, that would result in the following fps caps:
Multiplier: 540/X = FPS cap * X = VRR Hz
6x: 90 FPS/Hz = 88 FPS * 6 = 528 Hz
5x: 108 FPS/Hz = 105 FPS * 5 = 525 Hz
4x: 135 FPS/Hz = 130 FPS * 4 = 520 Hz
3x: 180 FPS/Hz = 171 FPS * 3 = 513 Hz
2x: 270 FPS/Hz = 250 FPS * 2 = 500 Hz
Given that the safety margin gets larger to account for the not perfectly precise frametime limiting, am I right to assume that you should be able to limit your FPS as shown above?
If yes, then you could get around 69 Hz more motion clarity compared to non-framegen, with the trade-off of more latency of course. But given that modern titles are nowhere near 1% low 459 FPS even with the fastest PC you can buy, frame gen sounds like a very good option, especially considering you need good 1% lows to reduce VRR flicker.
Thanks!