XL2411Z Frame Skipping?

[makitofikito]

Hello, so I stumbled across one thread at Reddit saying one of the AOC monitor is known to have problem with this, I had a strange feeling about my monitor since I had, but I never tried this test, so I decided to do so.
Result:
https://i.imgur.com/0PASLVI.jpg
I set camera on 1/5.
I already have this monitor over a year, but I never think about that, and if it is a failure, can i get a replacement?
Thanks

[lexlazootin]

Yea, that's pretty bust and defective.

AOC really like to cut corners with their monitors.

[makitofikito]

Ouh Are you 100% sure of that? should i send it back?

[Falkentyne]

Are you using a VT Tweak?

[lexlazootin]

Ouh Are you 100% sure of that? should i send it back?

If your monitor says it's 144hz then it should be displaying 144 frame a second.

Skipping frames is pretty bad thing, i think you might be able too make it not frame skip by creating a custom resolution in your GPU control panel at 1080p 144hz but with reduced blanking.

i'm not 100% sure this will help but it's worth a shot.

[makitofikito]

I don't know, i was tinkering with it while ago while i was trying to use blur reduction, but in the end i didn't like it so i switched, could that be the cause?

[makitofikito]

i restarted cru settings and its the same i think..i can see that empty gap even without picture

[Falkentyne]

Run reset-all.exe from CRU, restart the driver (restart64.exe) or computer, then try again. This will remove all custom resolutions.

And is instant mode enabled or disabled in the OSD?

[makitofikito]

Instant mode on