Blur Busters Forums

https://tftcentral.co.uk/wp-content/uploads/2023/06/response_1_new.png
Ultra Fast IPS panels can do average 2.2ms GtG with most ranges within 2ms, shouldn't that be enough for 500Hz?
With those newer backlight which has LED strip on both sides, I assume there would be barely any crosstalk?


1 ...

The display backlight flickers at 120 Hz (worst case, e.g., utilizing PWM) Flickering detected at a brightness setting of 100 % and below. There should be no flickering or PWM above this brightness setting.

The frequency of 120 Hz is very low, so the flickering may cause eyestrain and headaches ...

So what would the MPRT of an 120hz OLED device with a 120hz pwm frequency played at 120fps, 8ms or 4ms?



I initially wanted to get a zotac zone with a 120hz pwm (testiest by notebookcheck). They didn’t go into detail but I’m pretty sure it’s off for the same period it’s on.
an lg c1 at 120hz ...

My monitor doesn't' have DYAC and its 240 Hertz monitor.
What should i use?


The XL2540, which you've quoted, supports a backlight strobing solution as per: https://www.rtings.com/monitor/reviews/benq/zowie-xl2540

I'd run fps_max 0, Reflex enabled & fixed refresh rate.
The 240Hz target is too ...

How do you know that AOC monitor uses KSF phosphor (I could not find what manufacturer panel model it uses exactly) ?
Is it the very wide gamut and advertised DCI-P3 coverage (95%) that strongly hints at KSF phosphor ?


It's usually surmounted to one of the following approaches:
1) Find a ...

My UDIMMs have on-die ECC. What is the difference between that and an AM5 BIOS setting of "ECC"? Is it preferable to disable it in BIOS and let the on-die ECC do the error correcting instead?


This is a common misconception due to incorrect marketing from DRAM vendors. What I was referring to is ...

I think kuobe is an AI.
kuobe, that is kernel latency.
and it shows 100% correct.


1.) Ad hominem doesn't make your arguement sound, it makes you look foolish.
2.) No, that tool does not measure "kernel latency", nor is there any tool which showcases that properly (LatencyMon isn't one of them ...

I have to disagree, it is noticable. The number may be small in theory, but if you are actually playing aim trainers and can archieve top scores, you can notice the difference immidiatly. And it is such an easy improvement by just plugging the mouse into the correct USB port instead of chasing ...

https://youtube.com/shorts/FyiaG6tJzL4?si=hohqefOOa4LfaO4M
https://youtube.com/shorts/VMz4ZLgfeGY?si=oT1d6I7wibBvoudX

thats metods to check have already been 10 years, idk why someone on this forum not know about it.


Surely, you must know the DPC Latency Checker doesn't work since Windows 7 ...

Someone created a powershell script that tests and checks if you are using the lowest latency USB controller of your PC. On my MOBO which is ASUS ROG STRIX B650E-F it has two USB 3.2 Type A Gen 2 ports. So I plugged my Wooting 80HE and my mouse on those two USB ports, upon checking it with the ...