VSync vs Adaptive Half Refresh VSync when below VRR range?

Talk about NVIDIA G-SYNC, a variable refresh rate (VRR) technology. G-SYNC eliminates stutters, tearing, and reduces input lag. List of G-SYNC Monitors.
Post Reply
distino
Posts: 3
Joined: 19 Nov 2026, 22:22

VSync vs Adaptive Half Refresh VSync when below VRR range?

Post by distino » 19 Nov 2026, 22:38

Hello, I have 180HZ GSync monitor that I usually run at 120HZ refresh rate most of the time. I switch it back to 180HZ for a few multiplayer shooting games, but as of late I play more single player games and those I can't really get close to 180 fps, so I keep it at 120 most of the time.

There's however one game that I actually run at 30 fps (capped with RTSS). I don't really play it, just record some stuff so to speak. The monitor I have has a VRR range of 48-180 Hz. From what I see I have 2 options for this.

Option 1: GSync enabled + Normal VSync and while checking my monitor overlay in that game, I noticed that it switches itself to 60 Hz refresh rate. So with 30 fps cap I have the exact multiple of my monitor refresh rate which is a good thing from what I know.

Option 2: GSync enabled + forced 1/4 Adaptive VSync in Nvidia Profile Inspector (120/4=30). In this case my monitor stays at 120 Hz from what I saw. The input lag however is much more noticeable so I guess 1/4 VSync is working.

Which option should I be using?

User avatar
RealNC
Site Admin
Posts: 4665
Joined: 24 Dec 2013, 18:32
Contact:

Re: VSync vs Adaptive Half Refresh VSync when below VRR range?

Post by RealNC » Yesterday, 01:07

If you wanna use g-sync, then why not always run 180Hz and use a frame limiter to cap the games to whatever framerate you want?

Unless this causes more stutters in the games you play (can happen when games aren't hitting the vsync ceiling due to a frame limiter.) In that case, the best option if fractional vsync, as you do now. Without g-sync, you have several options to improve latency. But you're gonna need Special K for the capping:

https://forums.guru3d.com/threads/30-fp ... st-6438299

Personally, my FPS target for non-first person shooters is 90FPS. I use 180Hz with 1/2 vsync for that using one of the methods I described in that post. (I don't use g-sync because my OLED monitor has severe VRR flicker.) The best tool for the job I found and been using for a few years now is Special K.
Steam • GitHub • Stack Overflow
The views and opinions expressed in my posts are my own and do not necessarily reflect the official policy or position of Blur Busters.

distino
Posts: 3
Joined: 19 Nov 2026, 22:22

Re: VSync vs Adaptive Half Refresh VSync when below VRR range?

Post by distino » Yesterday, 11:13

RealNC wrote: ↑
Yesterday, 01:07
If you wanna use g-sync, then why not always run 180Hz and use a frame limiter to cap the games to whatever framerate you want?
That's what I used to do. However I also started to play Dead By Daylight and that game has an upper frame limit of 120. Even though once you get GSync monitor you're supposed to just use max pre-rendered frames to 1, enable GSync + VSync, use frame limiter and you're set in all games:

It says I can't link reddit here, but if you google PSA: Don't use RTSS/Change your RTSS framerate limiter settings you'll find the post

I noticed in DBD GSync + VSync does create some input lag (yes I capped to 117 with RTSS). It's not a lot but definitely noticeable once I turn off all Sync. Since I want to play without GSync and VSync in that game, I will have a refresh rate and framerate mismatch (180 vs 120). So I just lower my monitor to 120 HZ to keep it synced with framerate.

As for the case of that 1 specific game, 30 fps is outside of VRR range of this monitor (48-180) which is why I wanted to ask about it. I rememeber reading that if you have 60 Hz monitor, then capping to 30 and using half refresh sync is better than 30 cap with normal VSync. It was explained by you in this thread:
viewtopic.php?t=8028&sid=4991e9eb85261e ... 99b9f5f6dd

I suppose having 120HZ and using 1/4 VSync is the same like having 60Hz and using 1/2. I could actually just turn it to 60Hz and use 1/2, but I'd rather not add yet another case. Not sure if switching refresh mode in nvidia control panel so often below native is good for your monitor's health. 120 -> 180 switch happens rarely as of late, but that 1 game I do play rather often so I'd be switching from 120 to 60 rather often too.

If using fractional VSync does it matter if GSync is on or off? I know it matters when using standard VSync. Since 30 frames is outside of VRR range for this monitor, I had GSync disabled in that game for a while. One day I decided to enable it to see what happens and noticed in my monitor overlay that it switched from 120 to 60, so it seems if you go below VRR range, but keep GSync enabled it will try to match that frame rate with exact multiple.

However as you explained in that thread and here as well
RealNC wrote: ↑
Yesterday, 01:07
the best option if fractional vsync, as you do now.
It's better to use 1/4 VSync instead (latency also isn't a factor in this game). I suppose it doesn't matter if GSync is on or off in this case, it will be kept in 120 Hz regardless.

User avatar
RealNC
Site Admin
Posts: 4665
Joined: 24 Dec 2013, 18:32
Contact:

Re: VSync vs Adaptive Half Refresh VSync when below VRR range?

Post by RealNC » Yesterday, 22:20

distino wrote: ↑
Yesterday, 11:13
That's what I used to do. However I also started to play Dead By Daylight and that game has an upper frame limit of 120. Even though once you get GSync monitor you're supposed to just use max pre-rendered frames to 1, enable GSync + VSync, use frame limiter and you're set in all games:

I noticed in DBD GSync + VSync does create some input lag (yes I capped to 117 with RTSS). It's not a lot but definitely noticeable once I turn off all Sync. Since I want to play without GSync and VSync in that game, I will have a refresh rate and framerate mismatch (180 vs 120). So I just lower my monitor to 120 HZ to keep it synced with framerate.
Not sure I understand. If the game caps itself to 120FPS, then why use RTSS at all? Can't you just run 180Hz with g-sync enabled without RTSS and let the game run at 120FPS like it wants to?

As for the case of that 1 specific game, 30 fps is outside of VRR range of this monitor (48-180) which is why I wanted to ask about it.
That doesn't matter, because the driver will simply do LFC to run the display at 60Hz or 90Hz when g-sync is enabled, scanning out each frame two or three times.

I rememeber reading that if you have 60 Hz monitor, then capping to 30 and using half refresh sync is better than 30 cap with normal VSync. It was explained by you in this thread:
viewtopic.php?t=8028&sid=4991e9eb85261e ... 99b9f5f6dd
There's frame limiters that can do that now though. RTSS back-edge and Special K "normal", as well as RTSS scanline sync and SK latent sync. However, for that work without hiccups/stutters, you need to prevent the GPU from going into idle clocks because of the low GPU load. Meaning, enable "prefer maximum performance" in the Nvidia driver profile for this game. The frame limiter's accuracy depends on the GPU not going into low power mode (and with a lightweight game at 30FPS, this is guaranteed to happen.)

Another way to keep the GPU from going into power saving mode is to enable Reflex in SK and select "nothing but boost" as the Reflex mode.

When using fractional vsync instead, then the GPU going into a low power mode doesn't matter. It will not stutter. GPU clocks are only important when frame pacing is done by a frame limiter instead of vsync.

I suppose having 120HZ and using 1/4 VSync is the same like having 60Hz and using 1/2.
120Hz with 1/4 vsync is better than 60Hz with 1/2 vsync due somewhat lower latency. Other than that, the only other difference would be image quality if your display looks different at lower refresh rates. (My OLED display for example doesn't look very good at 60Hz. It has raised blacks and more near-black banding at low refresh rates. That's the nature of W-OLED panels.) If your display doesn't have that issue, then the latency is the only difference.

If using fractional VSync does it matter if GSync is on or off?
G-sync doesn't work with fractional vsync. Some people make use of this to prevent g-sync from activating without having to disable g-sync in the nvidia control panel or nvapp. So in your case, if you want to play with 120Hz and 1/4 vsync, you don't need to disable g-sync. It will simply not activate because of the fractional vsync.

As a side not, Special K allows you to set fractional vsync while the game is running without having to restart it. You can change the vsync setting live.
Steam • GitHub • Stack Overflow
The views and opinions expressed in my posts are my own and do not necessarily reflect the official policy or position of Blur Busters.

distino
Posts: 3
Joined: 19 Nov 2026, 22:22

Re: VSync vs Adaptive Half Refresh VSync when below VRR range?

Post by distino » Yesterday, 22:38

RealNC wrote: ↑
Yesterday, 22:20
Not sure I understand. If the game caps itself to 120FPS, then why use RTSS at all? Can't you just run 180Hz with g-sync enabled without RTSS and let the game run at 120FPS like it wants to?
g-sync and v-sync does introduce some input lag in that game, so I want to play without them. Without g-sync however I'd have refresh rate and frame rate mismatch since the game has an upper limit of 120 fps while my monitor would be staying at 180Hz. So I just lower my monitor refresh rate to get around it and match the frame rate.

As for the rest, I think I got all the informations and everything I wanted to know, so thank you very much.

User avatar
RealNC
Site Admin
Posts: 4665
Joined: 24 Dec 2013, 18:32
Contact:

Re: VSync vs Adaptive Half Refresh VSync when below VRR range?

Post by RealNC » Today, 01:18

distino wrote: ↑
Yesterday, 22:38
g-sync and v-sync does introduce some input lag in that game, so I want to play without them. Without g-sync however I'd have refresh rate and frame rate mismatch since the game has an upper limit of 120 fps while my monitor would be staying at 180Hz. So I just lower my monitor refresh rate to get around it and match the frame rate.
Doesn't that add latency as well due to vsync?
Steam • GitHub • Stack Overflow
The views and opinions expressed in my posts are my own and do not necessarily reflect the official policy or position of Blur Busters.

Post Reply