Asus PG27AQDM vertical banding
Posted: 06 Jan 2024, 01:13
Hi I’m looking for some information on an issue I’ve ran into on the PG27AQDM displays that I can’t find any information on. Essentially sometimes vertical banding is really bad and sometimes it is clean.
Typically whenever I turn it on after it’s been off for over 30 minutes or so I will get the intense banding and I’ll have to have it on for awhile and a pixel refresh will clean it up again. Sometimes though a pixel refresh will make it go from clean to intense again though. Sometimes I can turn it on after a whole night and it will be clean. When it’s intense I get a lot of Venetian blind/Mura effect as well.
Has anyone experienced this before? I’m aware banding can change somewhat after refreshes and other factors but on these monitors it’s always a big difference and the banding is in the same spots if it’s intense.
Any help would be great!
Typically whenever I turn it on after it’s been off for over 30 minutes or so I will get the intense banding and I’ll have to have it on for awhile and a pixel refresh will clean it up again. Sometimes though a pixel refresh will make it go from clean to intense again though. Sometimes I can turn it on after a whole night and it will be clean. When it’s intense I get a lot of Venetian blind/Mura effect as well.
Has anyone experienced this before? I’m aware banding can change somewhat after refreshes and other factors but on these monitors it’s always a big difference and the banding is in the same spots if it’s intense.
Any help would be great!