Blur Busters Forums

Hello, so I stumbled across one thread at Reddit saying one of the AOC monitor is known to have problem with this, I had a strange feeling about my monitor since I had, but I never tried this test, so I decided to do so.
Result:
https://i.imgur.com/0PASLVI.jpg
I set camera on 1/5.
I already have this monitor over a year, but I never think about that, and if it is a failure, can i get a replacement?
Thanks

Yea, that's pretty bust and defective.

AOC really like to cut corners with their monitors.

Ouh Are you 100% sure of that? should i send it back?

Are you using a VT Tweak?

makitofikito wrote:Ouh Are you 100% sure of that? should i send it back?

If your monitor says it's 144hz then it should be displaying 144 frame a second.

Skipping frames is pretty bad thing, i think you might be able too make it not frame skip by creating a custom resolution in your GPU control panel at 1080p 144hz but with reduced blanking.

i'm not 100% sure this will help but it's worth a shot.

i restarted cru settings and its the same i think..i can see that empty gap even without picture

Run reset-all.exe from CRU, restart the driver (restart64.exe) or computer, then try again. This will remove all custom resolutions.

And is instant mode enabled or disabled in the OSD?

Instant mode on